Skew monitor
A-61074 April 1997
Skew monitor defines the options required to enable/disable the
document skew monitor, set the amount of acceptable document
skew, and what action is to be taken when document skew is
detected.
NOTE: In order for the skew monitor to operate correctly, the
following conditions must be true:
— The amount of skew must be less than 30 degrees.
— The document(s) must be center-fed.
— The document(s) fed must be at least 3 inches / 75 mm
wide.
Select Skew Monitor from the Mode Configuration window.
Mode Number: 01
Mode Name: MODE01
Mode Configuration
Single
Index Format
6006
IA Field Width
3111
Level Rules
Supprs
IA Display Format
FthenR
Adjoining IA
None
Batching
Off
Length Monitor
Off
Skew Monitor
NA NA
Footswitch
Save & End Session
Save & Prev Menu
The following pages provide instructions on how to define the
document skew monitor options. When the skew monitor definitions
are complete, you will automatically be returned to this
window.
To close the Skew Monitor menu:
Select Previous Menu . Proceed to make any additional mode
configuration definitions.
Item #: 8.0
Patch Reader
Off
COIN2 Port Select
n/a
OCR
n/a
Bar Code Reader
Off
Printr Controller
Supprs
Front Printer
Off
Rear Printer
Off
Mode Name
MODE0
Overrides
No Sav
Don't Save & End Session
Don't Save & Prev Menu
Skew Monitor
On/Off
Detection Range
Error Response
Previous Menu
3-29