Bar Code Reader; On/Off; Bar Code Type; Codes Per Document - Kodak digital science 7500 Installation Instructions Manual

Bar code reader

A-61074 April 1997
NOTE: The bar code reader is an accessory which must be installed
and enabled by your Field Engineer.
Bar code reader defines the options required when using the bar
code reader accessory.
Select Bar Code Reader from the Mode Configuration window.
Mode Number: 01 Mode Name: MODE01
Mode Configuration
Single
Index Format
6006
IA Field Width
3111
Level Rules
Supprs
IA Display Format
FthenR
Adjoining IA
None
Batching
Off Length Monitor
Off
Skew Monitor
NA NA
Footswitch
Save & End Session
Save & Prev Menu
The following pages provide instructions on how to define the bar
code reader options. When the patch reader definitions are
complete, you will automatically be returned to this window.
To close the Bar Code Reader menu:
Select Previous Menu . Proceed to make any additional mode
configuration definitions.
NOTE: If the bar code reader was not defined as Present during
Accessory Configuration, the following message will appear:
The accessory that you requested is not enabled in
Accessory Configuration.
Press Enter .
Exit from Mode Configuration; refer to the section entitled,
Exiting Mode Configuration .
Contact your Field Engineer to install and enable this accessory.
Item #: 13.0
Patch Reader Off
COIN2 Port Select n/a
OCR n/a
Bar Code Reader Off
Printr Controller Supprs
Front Printer Off
Rear Printer Off
Mode Name MODE0
Overrides No Sav
Don't Save & End Session
Don't Save & Prev Menu
Bar Code Reader

On/Off

Bar Code Type

Codes Per Document

Minimum Code Length

Maximum Code Height

Scan Direction
Code Quality
Confirmation Tone
Bar Code Location
Previous Menu
3-43