Power Connector Cable - HP ZBook 17 G2 Maintenance And Service Manual

Power connector cable

NOTE: The power connector cable is included in the Cable Kit, spare part number 785212-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the optical drive (see
hard drive on page
7. Remove the keyboard (see
8. Remove the top cover (see
9. Remove the display assembly (see
10. Remove the graphics subsystem heat sink (see
Remove the power connector cable:
1. Remove the Torx T8M2.5×7.0 screw (1) that secures to the rear corner cover/left to the base enclosure.
2. Remove the rear corner cover/left (2).
The rear corner cover/left is available in the Plastics Kit, 733637-001.
3. Remove the Torx T8M2.5×4.0 screw (3) that secures to the power connector bracket.
4. Remove the power connector bracket (4).
The power connector bracket is available in the Bracket Kit, spare part number 737734-001.
5. Disconnect the power connector cable from the system board (5).
Battery on page 45).
Service cover on page
Optical drive on page
58).
Keyboard on page
Top cover on page
Display assembly on page
47).
56) or upgrade bay hard drive (see
61).
71).
81).
Graphics subsystem heat sink on page
Component replacement procedures 101
Upgrade Bay
96).