HP ZBook 17 G2 Maintenance And Service Manual page 112

4. Remove the battery (see
5. Remove the service cover (see
6. Remove the optical drive (see
hard drive on page
7. Remove the keyboard (see
8. Remove the top cover (see
9. Remove the graphics board fan/heat sink assembly (see
Remove the graphics board:
1. Remove the two Torx T8M2.5×4.0 screws (1) that secure the graphics board to the system board.
2. Lift the right edge of the graphics board until it rests at an angle (2), and then remove it from the
connector (3).
Reverse this procedure to install the graphics board.
100 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 45).
Service cover on page
Optical drive on page
58).
Keyboard on page
Top cover on page
47).
56) or upgrade bay hard drive (see
61).
71).
Graphics subsystem heat sink on page
Upgrade Bay
96).