Expresscard Assembly - HP ZBook 17 G2 Maintenance And Service Manual

ExpressCard assembly

Description
ExpressCard assembly
Before removing the ExpressCard assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the optical drive (see
hard drive on page
7. Remove the keyboard (see
8. Remove the top cover (see
Remove the ExpressCard assembly:
1. Remove the Torx T8M2.5×4.0 screw (1) that secures the light pipe to the computer.
2. Remove the light pipe (2).
3. Remove the four Torx T8M2.5×4.0 screws (3) that secure the ExpressCard assembly to the system
board.
4. Lift up on the right side (4) of the ExpressCard assembly to disconnect it from the
system board connector.
Battery on page 45).
Service cover on page
Optical drive on page
58).
Keyboard on page
Top cover on page
47).
56) or upgrade bay hard drive (see
61).
71).
Component replacement procedures
Spare part number
794578-001
Upgrade Bay
87