HP ZBook 17 G2 Maintenance And Service Manual page 64

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
Remove the WLAN module:
1. Position the computer with the front toward you.
2. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2/Aux" connects to the WLAN module "2/Aux" terminal.
3. Remove the two Phillips PM2.0×3.0 screws (2) that secure the WLAN module to the system board. (The
WLAN module tilts up.)
4. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
into the WLAN module slot.
Reverse this procedure to install the WLAN module.
52 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Battery on page
Service cover on page
The WLAN antenna cable labeled "1/Main" connects to the WLAN module "1/Main" terminal.
WLAN modules are designed with a notch to prevent incorrect insertion of the WLAN module
45).
47).