Table of Contents
Advertisement
Main memory
7.4
Replacing memory modules
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
Average software task duration: 5 minutes
7.4.1
Required tools
Preliminary and concluding steps: tool-less
●
Main steps: tool-less
●
7.4.2
Preliminary steps
Perform the following procedures:
"Disabling SVOM boot watchdog functionality" on page 65
Ê
Ê Locate the desired server node.
"Shutting down the server node" on page 45
Ê
Ê If applicable, remove all external cables from the server node.
"Removing the server node from the server enclosure" on page 46
Ê
Ê Disconnect the SATA cable(s) from the connectors on the system board
described in section
and take it out of the chassis.
Ê If a BBU is installed disconnect the BBU cable from the BBU connector on
the mezzanine SAS RAID controller described in section
boards" on page
"Removing the memory slot air ducts" on page 60
Ê
182
"Connectors on the boards" on page
251,
figure 152
and take it out of the chassis.
Upgrade and Maintenance Manual
251,
figure 150
"Connectors on the
CX250 S2
Advertisement
Table of Contents
