Installation; Important Message; Before You Start; General Safety - Regency Fireplace Products Gem54-NG Owners & Installation Manual

Gem54 series gas fireplace
Table of Contents

Advertisement

installation

IMpORTANT MESSAGE

SAvE THESE
INSTRUcTIONS
The Gem54™ Direct Vent Fireplace must be
installed in accordance with these instructions.
Carefully read all the instructions in this manual
first. Consult the "authority having jurisdiction"
to determine the need for a permit prior to
starting the installation. It is the responsibility of
the installer to ensure this fireplace is installed
in compliance with manufacturers instructions
and all applicable codes and complies with a
S5601 / AG601 clause 5.12, 13.2 and 5.12, 13.5.

bEFORE YOU START

INSTAllATION AND REpAIR SHOUlD
bE DONE bY AN AUTHORIZED SERvIcE
PERSON. THE APPLIANCE
SHOUlD bE INSpEcTED bEFORE
USE AND AT lEAST ANNUAllY bY A
PROFESSIONAL SERVICE PERSON.
MORE FREQUENT clEANING MAY
bE REQUIRED DUE TO EXcESSIvE
lINT FROM cARpETING, bEDDING
MATERIAL, ETC. IT IS IMPERATIVE
THAT cONTROl cOMpARTMENTS,
bURNERS AND cIRcUlATING AIR
pASSAGEWAYS OF THE ApplIANcE
BE KEPT CLEAN.
DUE TO HIGH TEMpERATURES, THE
ApplIANcE SHOUlD bE lOcATED
OUT OF TRAFFIc AND AWAY FROM
FURNITURE AND DRAPERIES.
WARNING: FAIlURE TO INSTAll THIS
ApplIANcE cORREcTlY WIll vOID
YOUR WARRANTY AND MAY cAUSE
A SERIOUS HOUSE FIRE.
cHIlDREN AND ADUlTS SHOUlD bE
AlERTED TO THE HAZARDS OF HIGH
SURFAcE TEMpERATURES, ESpE-
cIAllY THE FIREplAcE GlASS, AND
SHOUlD STAY AWAY TO AvOID bURNS
OR CLOTHING IGNITION.
YOUNG cHIlDREN SHOUlD bE cARE-
FUllY
SUpERvISED WHEN THEY
ARE IN THE SAME ROOM AS THE
APPLIANCE.
6
clOTHING OR OTHER FlAMMAblE
MATERIAl SHOUlD NOT bE plAcED
ON OR NEAR THE APPLIANCE.

GENERAl SAFETY

INFORMATION

1) The appliance installation must conform with
local codes or, in the absence of local codes,
with the current Installation and Building
Codes.
2) The appliance when installed, must be
electrically grounded in accordance with
local codes.
3) See general construction and assembly
instructions. The appliance and vent should
be enclosed.
4) This appliance must be connected to the
specified vent and termination cap to the
outside of the building envelope. Never vent
to another room or inside a building. Make
sure that the vent is fitted as per Venting
instructions.
5) Inspect the venting system annually for
blockage and any signs of deterioration.
6) Venting terminals shall not be recessed into
a wall or siding.
7) Any safety glass removed for servicing must
be replaced prior to operating the appliance.
8) To prevent injury, do not allow anyone who
is unfamiliar with the operation to use the
fireplace.
9) Wear gloves and safety glasses for protection
while doing required maintenance.
10) Be aware of electrical wiring locations in
walls and ceilings when cutting holes for
termination.
11) Under no circumstances should this
appliance be modified. Parts that have to be
removed for servicing should be replaced
prior to operating this appliance.
12) Installation and any repairs to this appliance
should be done by an authorized service
person. A professional service person should
be called to inspect this appliance annually.
Make it a practice to have all of your gas
appliances checked annually.
13) Do not slam shut or strike the glass door.
14) Under no circumstances should any solid
fuels (wood, paper, cardboard, coal, etc.) be
used in this appliance.
15) The appliance area must be kept clear and
free of combustible materials, (gases and
other flammable vapours and liquids).
"This uniT musT always
TeRminaTe / venT
diRecTly To The ouTdooRs."
Regency Gemfire™ Gas Fireplace

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gem54-ulpgGem54-lpg

Table of Contents