Table of Contents
Advertisement
Prior to serVicing the fan, ensUre Unit has cooleD to
room temPeratUre, all Power is DisconnecteD anD gas
sUPPlY it tUrneD off.
1) Remove the faceplate by lifting it up off the hinges on the sides of the
firebox.
2) Remove the door frame overlay by swinging out 45
lift up and out.
3) Remove the glass door.
b) Remove the 3 screws shown below at the bottom of the glass
.
door
c) Swing the door out 45
o
Regency Gemfire™ Gas Fireplace
from the bottom and
o
from the bottom and lift up and out.
FAN SERvIcE
4) Loosen 6 screws that secure the burner extenders. on burner tray,
located behind the burner on either side of the pilot assembly.
5) Lift out the 2 burner tray extenders.
Burner tray extenders
6) After extenders have been removed. Remove the 2 screws that
secure the burner tray, at the base of the firebox.
7) Slide the burner to the left and lift it out.
8) Remove 8 screws to remove the fan access panel cover - located on
the left hand side floor of the firebox.
MAINTENANcE
Burner tray extenders
Burner tray
Location of screws securing burner
Fan Access Panel
43
Advertisement
Table of Contents
