Regency Fireplace Products Gem54-NG Owners & Installation Manual page 44

MAINTENANcE
9) From the front of the unit, remove the two screws that are securing the fan
duct to the unit.
Remove the two screws securing the duct to the fan assembly. Set fan
duct off to right side closest to gas valve.
Remove Screws
10) From the fan access outlet within the firebox, remove the screws on the
left side of fan securing the flex and bracket.
11) Keeping fan assembly towards the rear wall, slide the fan assembly
approximately 3" to the right.
12) Remove from unit, bracket and attached 6" section of 3" duct from
elbow at left side and set aside.
13) Remove ground wire.
14) Near the switch box, cut cable tie and slide the heat sleeve to expose
spade connectors
44
Remove Screws
Disconnect ducting both sides.
Remove Screws
Top View
Cable Tie
15) Carefully disconnect spade connectors.
Spade connectors
16) Remove fan assembly by sliding to the left and lifting out through the fan
access panel. This will disconnect right side duct from fan assembly.
17) Reverse steps when service is completed. Once re-installed make sure 3"
ducts on either side of fan assembly are in position on collars.
Regency Gemfire™ Gas Fireplace