Table of Contents
Advertisement
The following table describes the parameters and buttons on this page:
Field
Local IP Address
Remote IP Address
Enable
Apply Changes
Reset
Current NAT Port Forwarding
Table
3.6.2.4 ALG
Click ALG in the left pane and the page shown in the following figure appears. Choose the NAT ALG and
Pass-through options, and then click Apply Changes.
3.6.2.5 NAT Exclude IP
Click NAT Exclude IP in the left pane and the page shown in the following figure appears. On the page, you can
configure some source IP addresses which use the purge route mode when accessing internet through the specified
interface.
Input a local IP address.
Input a remote IP address
Enable the current configured rule.
Submit the configurations.
Cancel the modification and reconfigure the settings.
Current configuration rule list.
53
802.11n Wireless ADSL2/2+ Router
Description
ADN-4101
Advertisement
Table of Contents
