Planet ADN-4101 User Manual page 30

802.11n wireless adsl 2/2+
Hide thumbs Also See for ADN-4101:
Table of Contents

Advertisement

The following table describes the parameters on this page:
Field
IP Address
Subnet Mask
Secondary IP
LAN Port
Link Speed/Duplex Mode
MAC Address Control
Add
3.4.1.2 DHCP
Dynamic Host Configuration Protocol (DHCP) allows the individual PC to obtain the TCP/IP configuration from the
centralized DHCP server. You can configure this router as a DHCP server or disable it. The DHCP server can assign
IP address, IP default gateway, and DNS server to DHCP clients. This router can also act as a surrogate DHCP server
(DHCP Relay) where it relays IP address assignment from an actual real DHCP server to clients. You can enable or
disable DHCP server.
Click DHCP in the left pane and the page shown in the following figure appears.
The following table describes the parameters on this page:
Field
DHCP Mode
IP Pool Range
Show Client
Enter the IP address of LAN interface. It is recommended to use an address from
a block that is reserved for private use. This address block is 192.168.1.1-
192.168.1.254.
Enter the subnet mask of LAN interface. The range of subnet mask is from
255.255.0.0-255.255.255.254.
Select it to enable the secondary LAN IP address. The two LAN IP addresses
must be in the different network.
You can choose the LAN interface you want to configure.
You can select the following modes from the drop-downlist:
100Mbps/FullDuplex, 100Mbps/Half Duplex, 10Mbps/FullDuplex,
10Mbps/Half Duplex, Auto Negotiation.
It is the access control based on MAC address. When selecting it, the host
whose MAC address is listed in the Current Allowed MAC Address Table can
access the modem.
Enter MAC address, and then click it to add a new MAC address.
If set to DHCP Server, the router can assign IP addresses, IP default gateway
and DNS Servers to the host in Windows95, Windows NT and other operation
systems that support the DHCP client.
It specifies the first and the last IP address in the IP address pool. The router
assigns IP address that is in the IP pool range to the host.
Click it, the Active DHCP Client Table appears. It shows IP addresses
25
802.11n Wireless ADSL2/2+ Router
Description
Description
ADN-4101

Advertisement

Table of Contents
loading

Table of Contents