Planet ADN-4101 User Manual page 21

The following table describes the parameters on this page:
Field
PPP Username
PPP Password
PPP Connection Type
After setting, click Next and the page as shown in the following figure appears.
The following table describes the parameters on this page:
Field
LAN Interface Setup
LAN IP
LAN Netmask
Enable Secondary IP
DHCP Server
Enable DHCP Server
Start IP
End IP
Max Lease Time
Enter the username for PPPoE dial-up, which is provided by your ISP.
Enter the password for PPPoE dial-up, which is provided by your ISP.
You can select Continuous, Connect on Demand, or Manual.
Continuous: After dial-up is successful, PPPoE connection is always on-line,
no matter whether the data is being transmitted or not. It is recommended to select
it.
Connect on Demand: After dial-up is successful, within the preset idle time,
no data is being transmitted, and the router automatically disconnects the PPPoE
connection.
In this case, you need to enter the idle time.
Manual: Select it, you need to dial up and disconnect the connection
mannually.
Enter the IP address of LAN interface. Its valid value is in the range of
192.168.1.1 to 192.168.255.254. The default IP address is 192.168.1.1.
Enter the subnet mask of LAN interface. Its valid value is in the range of
255.255.0.0 to 255.255.255.254.
Select the checkbox to enable the secondary LAN IP. The two LAN IP
addresses must be in the different network.
Select the checkbox to enable DHCP server.
Enter the start IP address that the DHCP sever assigns.
Enter the end IP address that the DHCP server assigns.
The lease time determines the period that the PCs retain the assigned IP
802.11n Wireless ADSL2/2+ Router
Description
Description
16
ADN-4101