Table of Contents
Advertisement
After setting, click Next and the page as shown in the following figure appears.
The following table describes the parameters on this page:
Field
Obtain an IP address automatically
Use the following IP address
Obtain DNS server addresses
automatically
Use the following DNS server
addresses
Enable NAT
For subsequent configuration, refer to the description in the above section PPPoE/PPPoA.
If the WAN connection type is set to 1483 Routed, the parameters of the WAN
connection type are the same as that of 1483 MER. For the parameters on these
pages, refer to the parameter description of 1483 MER.
Select it, DHCP automatically assigns the IP address for WAN
connection.
When selecting it, you need to manually enter the IP address,
subnet mask, and default gateway for WAN connection, which are
provided by your ISP.
Select it, DHCP automatically assigns DNS server address.
Select it, you need to manually enter the primary DNS server
address and secondary DNS server address.
Select it to enable network address translation (NAT). If you do not
select it and you want to access the Internet normally, you must
add a route on the uplink equipment. Otherwise, the access to the
Internet fails. Normally, it is required to enable NAT.
18
802.11n Wireless ADSL2/2+ Router
Description
ADN-4101
Advertisement
Table of Contents
