Table of Contents
Advertisement
After setting, click Next and the page as shown in the following figure appears.
The following table describes the parameters on this page:
Field
Obtain an IP address
automatically
Use the following IP address
Enable NAT
After setting, click Next and the page as shown in the following figure appears.
Select it, the DHCP assigns the IP address for PPPoE connection.
When selecting it, you need to enter the IP address for PPPoE
connection, which is provided by your ISP.
Select the checkbox to enable network address translation (NAT). If you
do not select it and you want to access the Internet normally, you must
add a route on the uplink equipment. Otherwise, the access to the Internet
fails. Normally, it is required to enable NAT.
15
802.11n Wireless ADSL2/2+ Router
Description
ADN-4101
Advertisement
Table of Contents
