Table of Contents
Advertisement
The following describes how to configure manual DMZ.
Step 1 Select Enable DMZ to enable this function.
Step 2 Enter an IP address of the DMZ host.
Step 3 Click Apply Changes to save the settings on this page temporarily.
3.6.2.2 Virtual Server
Click Virtual Server in the left pane and the page shown in the following figure appears.
The following table describes the parameters on this page.
Field
Service Type
Protocol
WAN Setting
WAN Interface
WAN Port
LAN Open Port
LAN IP Address
3.6.2.3 NAT Forwarding
Click NAT Forwarding in the left pane and the page shown in the following figure appears. Under 1483MER or
1483Routed mode, if NAPT (Network Address Port Translation) is enabled, the Local IP Address is configured as
192.168.1.3 and the Remote IP Address is configured as 202.32.0.2, the PC with the LAN IP192.168.1.3 will use
202.32.0.2 when it is connected to the Internet via the router without NAPT control.
You can select the common service type, for example, AUTH, DNS or FTP. You
can also define a service name.
If you select Usual Service Name, the corresponding parameter has the
default settings.
If you select User-defined Service Name, you need to enter the
corresponding parameters.
Choose the transport layer protocol that the service type uses. You can choose
TCP or UDP.
You can choose Interface or IP Address.
Choose the WAN interface that will apply virtual server.
Choose the access port on the WAN.
Enter the port number of the specified service type.
Enter the IP address of the virtual server. It is in the same network segment with
LAN IP address of the router.
802.11n Wireless ADSL2/2+ Router
Description
52
ADN-4101
Advertisement
Table of Contents
