Planet ADN-4101 User Manual page 55

The following table describes the parameters and buttons on this page:
Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Interface
Add Route
Update
Delete Selected
Show Routes
Static Route Table
Click Show Routes and the page shown in the following figure appears. The table shows a list of destination routes
commonly accessed by your network.
Select it to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to the destination device.
The metric cost for the destination.
The interface for the specified route.
Click it to add the new static route to the Static Route Table.
Select a row in the Static Route Table and modify the parameters. Then click it to
save the settings temporarily.
Select a row in the Static Route Table and click it to delete the row.
Click it, the IP Route Table appears. You can view a list of destination routes
commonly accessed by your network.
A list of the previously configured static IP routes.
802.11n Wireless ADSL2/2+ Router
Description
50
ADN-4101