Table of Contents
Advertisement
Field
PPP Settings
User Name
Password
Type
Idle Time (min)
WAN IP Settings
Type
Local IP Address
Netmask
Unnumbered
Add
Modify
Current ATM VC Table
After adding a PPPoE ATM VC to the table, click
appears. On this page, you can configure parameters of this PPPoE PVC.
(IGMP) function.
Enter the correct user name for PPP dial-up, which is provided by
your ISP.
Enter the correct password for PPP dial-up, which is provided by
your ISP.
You can choose Continuous, Connect on Demand, or Manual.
If set the type to Connect on Demand, you need to enter the idle
timeout time. Within the preset minutes, if the router does not detect
the flow of the user continuously, the router automatically
disconnects the PPPoE connection.
You can choose Fixed IP or DHCP.
If select Fixed IP, you should enter the local IP address, remote
IP address and subnet mask.
If select DHCP, the router is a DHCP client, the WAN IP address
is assigned by the remote DHCP server.
Enter the IP address of WAN interface provided by your ISP.
Enter the subnet mask of the local IP address.
Select this checkbox to enable IP unnumbered function.
After configuring the parameters of this page, click it to add new
PVC into the Current ATM VC Table.
Select PVC in the Current ATM VC Table, and modify the
parameters of this PVC. After finishing, click it to apply the settings
of this PVC.
This table shows the existed PVCs. It shows the interface name,
channel mode, VPI/VCI, encapsulation mode, local IP address,
remote IP address and other information. The maximum item of this
table is eight.
in the PPPoE mode and the page shown in the following figure
30
802.11n Wireless ADSL2/2+ Router
Description
ADN-4101
Advertisement
Table of Contents
