Table of Contents
Advertisement
Accessing the NX-595E - via the Web pages
Find the IP Address
DHCP is enabled by default which means an IP address will be assigned
automatically if your network supports DHCP.
To discover the IP address - use a keypad connected to the alarm system, enter
program mode, and navigate to device 191, Location 21.
Set the IP Address
If the IP address is empty (Location 21, Segment 1 will be 0), then program the
relevant locations below.
Location 19 – IP Location Settings
•
Enable option 1 to turn on DHCP which will allow your router to assign the
NX-595E and IP address automatically. Disable this option to manually
assign an IP address.
•
Enable option 2 to force SSL connections, turn off to allow either standard
or SSL connections.
•
Enable option 4 to allow ping command for troubleshooting.
•
Enable option 5 to allow the clock to automatically update using an
internet time server.
•
Enable option 6 to always allow remote access to the NX-595E
programming menus. At default the NX-595E programming menus are
only available when the NX-595E is in program mode (e.g. you enter the
device programming menu via a keypad connected to the NetworX
system).
Location 20 – IP Gateway
Location 21 – NX-595E IP Address
Location 22 – Subnet Mask
Navigating to the NX-595E
Enter the IP address of your NX-595E into the web browser to access the NX-
595E Configuration Server.
Note:
You may also connect using SSL or Secure Sockets Layer by typing https:
instead of http: for higher security communications between your browser and
the NX-595E. SSL connections may be slightly slower due to the encryption
process. You will also receive a warning window "There is a problem with this
websites security certificate", choose "Continue to this website" to connect to the
NX-595E.
24
NX-595E Installation Manual
Hide quick links:
Advertisement
Table of Contents
