Table of Contents
Advertisement
Web Updates:
When enabled, allows updating of the NX-595E Configuration
Server's web pages via FTP. Normally disabled.
Ping:
The "ping" command is always functional whilst the NX-595E is in program
mode and is defaulted to NOT operate whilst the NX-595E is in the normal run
mode. Enable this option to allow the NX-595E to respond to "ping" commands in
normal operation. For security reasons it is recommended this option remain
disabled during normal operation.
Web Time Updates:
compare it against GMT time. This is done every 15min and will update itself if
the variance is greater than 3 minutes.
NetworX Protocols:
5min after power up. Allows devices such as iPhones and UHS devices to
communicate with the NX-595E via NetworX protocols.
xConnect:
This enables the app and automatic email configuration. Can only be
disabled from a keypad.
IP Address:
An Internet Protocol (IP) address is a numerical label that is
assigned to devices participating in a computer network. If DHCP is enabled and
supported by your network, the NX-595E IP address will be automatically
assigned, otherwise you will be required to enter your unique IP address here.
Subnet Mask:
Allows a network to be divided into subnets, and allows the flow
of network traffic between hosts to be segregated based on a network
configuration. Applying the subnet mask to an IP address splits the address into
two parts, an "extended network address" and a host address. A typical subnet
mask is 255.255.255.0
Primary DNS:
IP address of the primary DNS server. DNS (Domain Name
System) allows dedicated servers on the internet to be assign both an IP address
and a corresponding name, called a domain name.
Secondary DNS:
IP address of the secondary DNS server. DNS (Domain Name
System) allows dedicated servers on the internet to be assign both an IP address
and a corresponding name, called a domain name.
SSL Port:
Selectable port configuration, a default port is 443.
Web Access Passcode:
595E, it does not affect the operation of other features.
xConnect Server 1:
remote web access, iPhone app and email services without having to set up port
forwarding.
xConnect Server 2:
28
The NX-595E will check its internal and use the internet to
This protocol is disabled by default, but is active for the first
This code allows the iPhone app to connect to this NX-
This server address should not be changed, it enables the
This server address should not be changed.
NX-595E Installation Manual
Hide quick links:
Advertisement
Table of Contents
