Enrolling The Nx-595E; Accessing The Nx-595E - Via A Touch Tone Phone - Interlogix NX-595E Installation Manual

Enrolling the NX-595E

NetworX control panels can automatically find and store all modules that are
connected to the communications bus, such as NX-595E, keypads, zone
expanders, wireless receivers, output boards and other modules. This allows for
polled supervision of these modules, and if the NetworX panel does not detect an
enrolled module, a service condition will be generated.
The NX-595E module will be automatically enrolled if you perform the defaulting
procedure described above. Enrolling takes about 12 seconds and user codes
will not be accepted during this time.
Accessing the NX-595E – via a Touch Tone
Phone
This section describes how to access the NX-595E via an off site touch-tone
phone. The NX-595E must be on an independent line to the touch-tone phone
from which you are trying to connect. The NX-595E must be pre-programmed by
your security service provider to automatically answer the incoming call once the
predetermined number of calls / rings have been reached. When the desired
number of calls / rings has been reached the NX-595E will grab the phone line
and announce the following.

Enter your code for system access, press star to cancel
Enter your user / master code / Installer code (default master code is 1234 and
default Installer code is 9713), the NX-595E will announce the recorded system
name (if recorded) and list all accessible main menus, you can now make your
selection as required.

You are now connected to (system name)......
Press 1 for system status
Press 2 for system control
Press 3 for intercom control
Press 4 for output control
Press 5 for message bank
Press 0 for system configuration *
Press # to exit
* Denotes master code access only
The above sequence will be shown throughout this manual as
Location 2, Dial attempts must be set to the desired number of rings before the
NX-595E will answer an incoming call to begin a voice session. Location 1,
segment 2, answering machine defeat can also be used to bypass onsite
answering machines.
If answering machine defeat is enabled, accessing the NX-595E remotely is
accomplished by calling the phone number the NX-595E is connected to and
allowing it to ring once or twice, then hanging up, waiting 10 seconds, then
NX-595E Installation Manual
[PIN].
19