Aiphone IX-MV Setting Manual page 35

 For stateless IPv6 Address
 Create new data
Use flowchart to create new configuration, e.g., when installing a new system.
1. Install a device (e.g., router) which can transmit RA (supports the stateless IPv6
setting).
Do not change the device so that it cannot transmit Router Advertisement (RA).
For how to set up, refer to the manual of the device.
2. Set "Language."
➤ P.95
"3. Language"
3. "New System."
"1.1. Create New System"
4. Configure using "Settings (Table View)."
Configure the station according to the description of each item. "System settings (Settings (Table
➤ P.107
View))"
5. Install all stations.
Note the MAC addresses of all the stations.
6. Associate the created setting data to each station.
"4.2. Association Settings"
Each station is restarted and IPv6 Address will be automatically configured.
If IP Address fails to be automatically configured, it will become "FDC2::7000." If this happens, cycle power to
the station, and then the IP Address will be automatically reconfigured.
7. Choose "IPv6" for the communication method of IX Support Tool.
"2.10. IX Support Tool Settings"
8. Upload the setting data to all the stations.
"1.5. Upload Settings To Station"
9. Set the clock of each station.
➤ P.113
"1.3. Time"
10.Set "LANGUAGE" of each Master Station.
Refer to IX Master Station Operation Manual.
11.Done.
Introduction
➤ P.81
➤ P.97
➤ P.93
➤ P.85
35