For IPv4 address with DHCP
Create new data
Use flowchart to create new configuration, e.g., when installing a new system.
1. Verify managed DHCP environment exists and that each station has been assigned
a static IP address.
2. Set "Language."
➤ P.95
"3. Language"
3. "New System."
"1.1. Create New System"
4. Configure using "Settings (Table View)."
Configure the station according to the description of each item. "System settings (Settings (Table View))"
5. Install all stations.
Note the MAC addresses of all the stations.
6. Associate the created setting data to each station.
"4.2. Association Settings"
Each station is restarted and the IP address assigned by DHCP server will be assigned.
If a DHCP address cannot be assigned, it will default to "192.168.1.160."
7. Upload the setting data to all the stations.
"1.5. Upload Settings To Station"
8. Set up the clock of each station.
➤ P.113
"1.3. Time"
9. Set "LANGUAGE" of each Master Station.
Refer to IX Master Station Operation Manual.
10.Done.
Important
Impo
ant
Due to the architecture of the IX system, DHCP configuration is only recommended
for network environments utilizing managed (static) IP address leasing.
Save the settings after configuring the system.
Refer to "Where the setting file is saved"
If the setting file is lost, station settings will need to be reconfigured.
Introduction
➤ P.81
➤ P.97
➤ P.85
➤
P.82.
22
➤ P.107