Denso BHT-8000 User Manual page 76

(2) Communications protocol option menu
Setting the interface port
Selecting "2:PROTOCOL" on the SET CONNECTOR screen calls up
the screen shown at left.
Highlighted is the current setting.
[1] SERIAL No.:
[2] H. PARITY:
[3] LINKUP TIME:
[4] FIELD SPACE:
Select a desired item by using the numerical keys or F5 and F6. Then
select a desired setting by using the F7 and F8.
To return to the SET CONNECTOR screen, press the C key.
If the BHT-Ir protocol has been selected, the serial number and
horizontal parity settings will be ignored.
Selecting the "3:COM PORT" on the SET COMMUNICATION menu
calls up the screen shown at left.
Highlighted is the current setting.
[1] BASIC:
[2] SYSTEM MODE:
Select a desired item by using the numerical keys or F5 and F6, and
then select a desired setting by using the F7 and F8.
To return to the SET COMMUNICATION menu, press the C key.
Selects whether or not the system will add
serial numbers to data blocks.
Selects whether or not the system will add a
horizontal parity.
Selects the timeout length (in seconds) to be
applied when a link is to be established.
Selects whether trailing spaces in data fields
will be trimmed (Ignore) or retained (Data).
Selects the IrDA or direct-connect interface
port to be used for user programs written in
BHT-BASIC (OPEN "COM:").
Selects the IrDA or direct-connect interface
port to be used for downloading or uploading
files in System Mode.
60