Denso BHT-8000 User Manual page 73

[4.5] Setting the communications environments
After the BHT is initialized, the interface port and communications parameters are set as listed in the
default table below. Do not access them unless necessary.
Interface port
Communications protocol
Communications parameters
for the IrDA interface port
TRANSMIT SPEED
PROTOCOL (Protocol options)
Listed below are the default communications parameters for the direct-connect interface.
Communications parameters
for the direct-connect interface port
TRANSMIT SPEED
PARITY BIT (Vertical parity)
DATA BIT (Character length)
STOP BIT (Stop bit length)
PROTOCOL (Protocol options)
Selecting the "5: COMMUNICATION" on the SET SYSTEM menu
calls up the screen shown at left.
[1] OPTICAL:
[2] CONNECTOR:
[3] COM PORT:
[4] PROTOCOL TYPE: Switches to the communications protocol
Select a desired screen by using the numerical keys or F5 and F6
keys, and then press the ENT key.
To return to the SET SYSTEM menu, press the C key.
Chapter 2 Getting Started the BHT and System Mode
Optical (IrDA interface port)
BHT-protocol
Defaults
115200 bps
SERIAL No.: ON (Adds serial numbers to data
blocks.)
H. PARITY: ON (Adds a horizontal parity.)
LINKUP TIME: 30 seconds
FIELD SPACE: Ignore (Trim)
Defaults
115200 bps
None
8 bits
1 bit
SERIAL No.: ON (Adds serial numbers to data
blocks.)
H. PARITY: ON (Adds a horizontal parity.)
LINKUP TIME: 30 seconds
FIELD SPACE: Ignore (Trim)
Switches to the communications parame-
ters setting screen for the IrDA interface.
Switches to the communications parame-
ters setting screen for the direct-connect
interface.
Switches to the interface port setting
screen.
type setting screen.
57