Denso BHT-8000 User Manual page 29

JIS Level 1 and Level 2 Font Files
These files contain font data required for displaying Kanji characters on the LCD.
The BHT can display the Kanji characters not only in the conventional standard-size font (16 dots wide
by 16 dots high) but also in the small-size font (12 dots wide by 12 dots high) in application programs. It
can also display the double-width Kanji characters of those 16-dot and 12-dot fonts in application
programs.
If you do not need to display Kanji characters, you may delete these JIS font files. After deletion, the
memory area which was occupied by these files can be used as a user area. For the deleting procedure,
refer to Section 2.4, "Initializing the BHT System" or Subsection 2.5.3, "[ 8 ] Deleting Font Files."
The names of the JIS font files are:
FNT16J1.FN3 (JIS Level 1 font, 16-dot)
FNT16J2.FN3 (JIS Level 2 font, 16-dot)
FNT12J1.FN3 (JIS Level 1 font, 12-dot)
FNT12J2.FN3 (JIS Level 2 font, 12-dot)
User Programs
You can develop application programs to meet individual job requirements by using the BHT-BASIC
Compiler. To download those user programs to the BHT, use Ir-Transfer Utility C/Ir-Transfer Utility
E/Transfer Utility.
Chapter 2 Getting Started the BHT and System Mode
13