Unpacking The Projector - Barco DP K-19B Series User And Installation Manual

The power cord required to connect the projector with the power net is not delivered with the projector. It is the
responsibility of the customer to provide the correct type of power cord. The cross-sectional area of the
conductors in the power supply cord shall not be less than 4 mm² or 10 AWG, minimum 300V.
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that
the instrument panel and cabinet be grounded. In no event shall this projector be operated without an
adequate cabinet ground connection.
The AC supply must be installed by a qualified electrician in conformance to local codes. Hardware, wire sizes
and conduit types must comply with local codes.
A readily accessible disconnect device shall be incorporated externally to the equipment for removal of the
power to the equipment mains terminals.
The building installation must be provided with a circuit breaker of max. 40A to protect the complete unit.
WARNING: Disconnect the power to the unit mains terminals and unplug power cord at UPS inlet
for removal of all power from the unit
UPS requirements
The Uninterruptible Power Supply (UPS), also known as a Continuous Power Supply (CPS), must have an
output voltage of 200-240V at 50-60Hz and must be capable of delivering an output current of 5,5 amperes.
This UPS provides only power for the electronics and not for the lamp.
The connection between the UPS unit and the UPS inlet of the projector must be done with a certified AC
power supply cord of minimum 0,75 mm² or 18 AWG and minimum 300V.
CAUTION: The 200–240V power outlet (UPS OUTLET) of the projector may not be used to provide
the UPS unit with power! The UPS OUTLET of the projector may only be used for connection to the
UPS INLET of the projector.
The DPxK-19B/23B/P does not have a built in UPS unit.
Exhaust outlet for external fan
The exhaust outlet has an output voltage of 200– 240V at 50– 60 Hz; switched and maximum 3 amperes is
allowed.
The connection between the exhaust outlet and the external blower must be done with a certified AC power
supply cord of minimum 0,75 mm² or 18 AWG and minimum 300V.
CAUTION: The 200–240V power outlet (exhaust outlet) of the projector may not be used to provide
power to any other device than an external exhaust fan. Maximum allowed current : 3A.
Projector weight
Do not underestimate the weight of the DPxK B. The projector weights about ±133 kg (±293 lb.) without lens.
Be sure that the pedestal on which the projector has to be installed is capable of handling five (5) times the
complete load of the system.
Barco offers a pedestal for the DPxK-19B/23B/P. This universal pedestal allows a solid and easy
setup of the projector. The universal pedestal has a separate compartment to install the UPS unit for
the DPxK-19B/23B/P. Futhermore, the universal pedestal contains a standard 19" rack to build in
the projector peripherals such as alternative content switchers.

2.2 Unpacking the projector

What has to be done ?
Upon delivery, the projector is packed in a carton box upon a wooden pallet and secured with banding and
fastening clips. Furthermore, to provide protection during transportation, the projector is surrounded with
General
R5905753 /17 DPxK-19B/23B/P 23