Using The Transfer Output; Transfer Output Function - Omron E5C User Manual

5 Advanced Operations

5-13 Using the Transfer Output

5-13-1 Transfer Output Function

A transfer output can be used on models that have a transfer output.
Precision and User Calibration
Precision
±0.3% FS
* For details on calibration, refer to Section 6 Parameters.
Transfer Output Signal (Initial Setting Level)
You can use the Transfer Output Signal parameter to specify whether to output a current or voltage
from the transfer output.
Terminal Arrangement
E5CC
Option number: 006
Transfer output
4-20: 4 to 20mA
Transfer Output Type (Initial Setting Level)
You can use the Transfer Output Type parameter to specify any of five types of data to output.
Transfer output type
OFF (default)
*1
Set point
Set point during SP ramp
PV
MV monitor (heating)
MV monitor (cooling)
Valve opening
*1 When the SP is selected, the remote SP will be output while the SP Mode parameter is set to the Remote SP
Mode.
*2 This function can be set for a Position-proportional Model, but the setting will be disabled.
*3 This function can be set for standard control or for a Position-proportional Model, but the setting will be
disabled.
*4 This parameter is displayed only for a Position-proportional Model and only when there is a potentiometer
input.
5 - 36
User calibration
Supported.*
E5EC/E5AC
Option number: 011, 012, 013, or 014
P
V
Q
Transfer output
I
R
Setting range
1-5v: 1-5 V
Display
off
---
SP lower limit to SP upper limit
sp
sp-m
SP lower limit to SP upper limit
Input setting range lower limit to input setting range upper limit or
pV
Scaling lower limit to scaling upper limit
−5.0 to 105.0 (heating/cooling control: 0.0 to 105.0)
*2 mV
*3 0.0 to 105.0
c-mV
−10.0 to 110.0
*4 V-m
31
V
32
I
33
Default
4-20
Setting range
E5@C Digital Temperature Controllers User's Manual (H174)