Omron E5C User Manual page 237

cmwt
• This parameter enables/disables writing of parameters to the E5@C from the host
(personal computer) using communications.
• This parameter is not displayed if the Event Input Assignment 1 to Event Input
Function
Assignment 6 parameters are set to enable/disable communications writing.
ON:
Setting
OFF:
• The Communications Writing parameter will be automatically turned ON if the Protocol
Setting
communications, or the MC Protocol (format 4).
Related Parameters
See
See
Communications Setting Level: Page 6-92
Protocol Setting, Communications Unit No., Communications Baud Rate,
Communications Data Length, Communications Parity, and Communications Stop Bits
spmd
This parameter sets the SP mode. In Local SP Mode, the local SP that is set inside the Dig-
ital Controller is used as the SP. In Remote SP Mode, the remote SP that is specified with
an external signal (e.g., 4 to 20 mA) is used as the SP.
Function
LSP: Local SP and RSP: Remote SP
Related Parameters
See
See
Remote SP Enable (Advanced Function Setting Level): Page 6-81
E5@C Digital Temperature Controllers User's Manual (H174)
Communications Writing
Setting rage
Writing enabled
Writing disabled
parameter is set
000
SP Mode
Setting range
Communications must be supported.
The Event Input Assignment 1 to Event Input
Assignment 6 parameters must not be set to
enable/disable communications writing.
Default
OFF
to component communications,
There must be a remote SP input.
The ST parameter must be set to OFF, and the
Remote SP Enable parameter must be set to ON.
The Event Input Assignment 1 to Event Input
Assignment 6 parameters must not be set to
change the SP mode.
Default
LSP
6 Parameters
Host Link (FINS)
6 - 21
6