Omron E5C User Manual page 274

6 Parameters
mot
The Travel Time parameter is set to the time from when the valve is completely open until it
is completely closed. The Travel Time parameter is set automatically when motor calibration
is performed.
Function
Operation
Related Parameters
See
See
Motor Calibration (Initial Setting Level): Page 6-57
sqr
This parameter enables and disables square root extraction.
Function
Setting
Related Parameter
See
See
Extraction of Square Root Low-cut Point (Adjustment Level): Page 6-36
amoV
• Set the Move to Advanced Function Setting Level parameter set value to "−169."
• Move to the advanced function setting level either by pressing M Key or O Key or by
waiting or two seconds to elapse.
Function
Related Parameter
See
See
Initial Setting/Communication Protect (Protect Level): Page 6-4
6 - 58
Travel Time
Setting range
1 to 999
Extraction of Square Root Enable
000
Setting range
on: Enabled, off: Disabled
Move to Advanced Function
Setting Level
A Position-proportional Model must be used.
Unit Default
Seconds 30
An analog input must be supported.
Default
OFF
The Initial Setting/Communications Protect
parameter must be set to 0.
E5@C Digital Temperature Controllers User's Manual (H174)