Starter Motor Inspection - HYOSUNG Aquila 250 Service Manual

5-13 ELECTRICAL SYSTEM
◉ STARTER MOTOR REMOVAL AND
DISASSEMBLY
● Disconnect the starter motor lead wire ①. (Refer to
page 3-3)
● With loosen the bolt ②, remove the starter motor.
(Refer to page 3-8)
● Disassemble the starter motor.

◉ STARTER MOTOR INSPECTION

� CARBON BRUSH
Inspect the brushes for abnormal wear, crack or
smoothness in the brush holder.
If the brush has failed, replace the brush sub assy.
� COMMUTATOR
Inspect the commutator for discoloration, abnormal wear
or undercut �.
If the commutator is abnomally worn, replace the arma-
ture.
When surface is discolored, polish it with #400 sand
paper and clean it with dry cloth.
� ARMATURE COIL INSPECTION
Check for continuity between each segment.
Check for continuity between each segment and the
armature shaft.
If there is no continuity between the segments or there
is continuity between the segment and shaft, replace the
starter motor with a new one.
Pocket tester : 09900 - 25002
①
②
Segment
�