HYOSUNG Aquila 250 Service Manual page 80

■ GEARSHIFT CAM DRIVEN GEAR
● When installing the gearshift into the cam driven
gear, the big shoulder � face toward outside as
shown in figure.
● Install the cam guide and pawl lifter.
When installed, apply the THREAD LOCK "1324"to
the securing screw.
THREAD LOCK "1324"
■ GEARSHIFT SHAFT
Install the gear shifting shaft. Match the center teeth of
the gear on the shifting shaft with the center teeth on the
shifting driven gear as shown.
CAUTION
After the cam driven gear, cam guide, gear shift
shaft and neutral cam stopper have been fitted,
confirm that gear change is normal while turning,
the countshaft and driveshaft. If gear change is
not obtained, it means that assembly of gears or
installation of gear shifting fork is incorrect. In
this case, disassemble and trace the mistake.
◉ OIL PUMP
● Before installing the oil pump, apply the engine oil to
the contact face of case, outer rotor, inner rotor and
shaft.
● Apply a small quantity THREAD LOCK "1324"to the
oil pump securing screws.
THREAD LOCK "1324"
● Tighten the oil pump securing screws.
A A
A
5th
4th
3rd
2nd
N
1st
ENGINE 3-42
A
A A