HYOSUNG Aquila 250 Service Manual page 85

3-47 ENGINE
● Install the clutch release arm as following:
① Turn the clutch release shaft toward(This time,
mark on the shaft align outside contact line the
stopper screw) the right.
② Install that the cable connecting center line of the
clutch release arm align matching mark rightside of
the case as shown the right figure.
◉ NEUTRAL CAM STOPPER
● Put in the neutral cam stopper, spring and washer,
tighten the cam stopper plug to the specified torque.
Cam stopper plug
: 20~25 N∙m(2.0~2.5 kg∙m)
◉ OIL DRAIN PLUG
● Tighten the oil drain plug to the specified torque.
Engine oil drain plug
: 18~20 N∙m(1.8~2.0 kg∙m)
◉ STATOR
● Apply a small quantity of THREAD LOCK "1324"to
the threaded parts of screws.
THREAD LOCK "1324"
◉ STARTER CLUTCH
● When installing the starter clutch and rotor, apply the
THREAD LOCK "1324"to the bolts and tighten to
the specified torque.
THREAD LOCK "1324"
Starter clutch bolt
: 15~20 N∙m(1.5~2.0 kg∙m)
Stopper screw
Clutch release
arm bolt
Clutch release
arm
Crankcase
matching mark
Release camshaft
notch mark