4-1-33 FI SYSTEM DIAGNOSIS
SENSORS
◉ ◉ IAP SENSOR INSPECTION
The intake air pressure (IAP) sensors NO.1 ①
NO.2 ②
are installed at the upside of each intake
pipe. (Refer to page 4-1-22)
◉ ◉ IAP SENSOR REMOVAL AND
INSTALLATION
● Remove the fuel tank.
● Remove the IAP sensor from the intake pipe.
● Install the IAP sensor in the reverse order of
removal.
◉ ◉ ET SENSOR INSPECTION
The engine temperature (ET) sensor ③
the engine case. (Refer to page 4-1-20)
◉ ◉ ET SENSOR REMOVAL AND
INSTALLATION
● Remove the ET sensor.
● Install the ET sensor in the reverse order of
removal.
ET sensor : 18 N∙ ∙ m (1.8 kgf∙ ∙ m)
and
is installed at
42
①
②
③