Battery Installation - HYOSUNG Aquila 250 Service Manual

⑤ Separation of electrolyte container
After confirming that you entered the electrolyte into bat-
tery completely, remove the electrolyte containers from
the battery.
CAUTION
Draw the empty receptacle out slowly because
there may be a chance which remaining elec-
trolyte vaporize.
⑥ Insert of the caps
Insert the cap into the filler holes, pressing it firmly so
that the top of the caps do not protrude above the up per
surface of the battery' stop cover.

◉ BATTERY INSTALLATION

s battery installation order pay attention
to following points :
① Romove the seat, right frame cover and battery support.
② Lay down (+) positive terminal of the battery at leftside
of the battery case (on the motorcycle).
③ Install (+) positive lead wire at the battery terminal.
④ Put on the rubber cap at the (+) positive terminal of the
battery.
⑤ Install (-) negative lead wire at the battery terminal.
⑥ Install the battery support and right frame cover.
CAUTION
If install first the lead wire at the battery then
lay down at the battery case, will be installed
the opposite direction[(+) positive terminal
face on the rightside of the motorcycle] as that
length of the (+) lead wire has no something extra.
This time, the battery could not lay down per-
fectly and to occur the short circuit etc. if the
battery install the opposite direction.
ELECTRICAL SYSTEM 5-20
Insert the caps firmly
(-) Lead wire
⇒ ⇒ Front side