Replacing The G-Trac Sensor - Invacare STORM4MAX Service Manual

®
Invacare - STORM
8.2.5

Replacing the G-Trac sensor

Requirements:
· 5 mm Allen key
· 10 mm socket wrench
Uninstalling the G-Trac sensor:
·
Remove the seat, as described in chapters 8.14.1 and 8.14.5.
·
Switch the electronics of the wheelchair OFF.
·
Remove the rear cover, as described in chapter 8.1.1.
·
Take note of the positions of all cables and the sockets that they are connected to. Mark the
connectors and sockets or take a photograph with a digital camera.
·
In the illustration above, you see the power module (3) and the positions of the optional lighting
circuit board (2), of the optional actuator module (1) and of the optional G-Trac sensor (4).
·
Remove the rear cover, as described in chapter 8.1.1.
·
Press both locking bolts inwards and open the battery box cover.
4
MAX SERVICE MANUAL
49