Replacing The Seat Support With Electric Tilt Module - Invacare STORM4MAX Service Manual

®
Invacare - STORM

8.14.5 Replacing the seat support with electric tilt module

CAUTION: Danger of crushing!
· The seat/seat support are very heavy. You should seek help from a second person who can
secure the seat and help when carrying.
Requirements:
· T40 torx wrench
· oblique pliers
· cable ties
Dismantling the seat support:
·
Remove the legrests.
·
Remove the armrests.
·
Remove the seat cushion.
·
Remove any existing cable ties holding the cables on the remote or lighting. Remove the
cables from the stuck on clamps.
·
Loosen the cap nuts of the headlight mountings using an 8 mm jaw spanner (see
chapter 8.7.4).
·
Put the headlight and the mounting in a safe place on the rear part of the battery compartment
cover.
·
Remove the connecting cable to the chassis from the remote or form the optional actuator
module.
·
Remove the cable or cables so that there is no longer any cable connection between the seat
and the chassis.
·
Remove the pin retainer (1).
·
Remove the bolt (2).
·
Swing the tilt actuator (6) forwards.
4
MAX SERVICE MANUAL
103