Advertisement
ADJUSTING STINGRAY AND
STARGAZER HAND BRAKES
(FIGURE 10)
Adjusting Hand Brake
NOTE: COUNTERCLOCKWISE/CLOCKWISE direc-
tions are determined by standing behind the rollator (us-
ers position).
1. Loosen the hand brake adjustment nut by turning
CLOCKWISE.
2. Perform one (1) of the following:
A. Loosen hand brake tension - turn hand brake
nut COUNTERCLOCKWISE.
B. Tighten hand brake tension - turn hand brake
nut CLOCKWISE.
3. Turn the hand brake adjustment nut CLOCKWISE to
secure in place.
REPLACING BRAKE WIRE/
ADJUSTING CASTER HOUSING
Brake
REPLACING/ADJUSTING PUSH HANDLE
Push
Handle
Adjustment
Knob
OUTSIDE
FIGURE 10 - REPLACING/ADJUSTING STINGRAY AND STARGAZER BRAKES/
Brake Cable
Caster Housing
Adjustment Nut
Caster Housing
Nut
Brake Wire
Hex Screw
INSIDE
Screw
Frame
ADJUSTING STINGRAY AND STARGAZER PUSH HANDLE
4. Perform one (1) of the following:
A. Acceptable tension - repeat STEPS 1 - 3 for op-
posite side, if necessary.
B. Unacceptable tension - refer to ADJUSTING
CASTER HOUSING in this procedure of the in-
struction sheet.
5. Refer to LOCKING/UNLOCKING/USING HAND
BRAKES in the Stingray/Stargazer instruction sheet
Part Number 1076167.
Adjusting Caster Housing
1. Turn the caster housing nut on the bottom COUN-
TERCLOCKWISE to loosen.
2. Turn the caster housing adjustment nut COUNTER-
CLOCKWISE to loosen.
3. Retighten caster housing adjustment nut and caster
housing nut by turning CLOCKWISE.
4. Repeat STEPS 1 - 3 until tension is acceptable.
REPLACING BRAKE CABLE
Guide
Frame
REPLACING/ADJUSTING HAND BRAKE
Push
Handle
Hand
Brake
Hand
Push
Brake
Handle
11
Brake
Cable
Phillips Screw
Mounting
Hole
Back Support
Hand Brake
Adjustment
Nut
Hand
Brake Nut
Back Support
Advertisement
