Replacing The Seat Tilting (Wheelchair Without Lifter) - Invacare Bora XTR Series Service Manual

SERVICE MANUAL

7.17.2 Replacing the seat tilting (wheelchair without lifter)

Note
When an electrical adjustment option is retrofitted, then this option needs to be activated in the
driving program as well if you have an ACS2 remote.
Requirements:
· flat screwdriver, blade width approx. 6 mm
· oblique pliers
· small hammer
· cable binder
· Remove legrests.
· Release seat (1) and tilt forwards.
· Disconnect the remote bus cable from the
electronics module or ACT.
· Lift the seat out of the front anchorage and
remove it. The seat has a heavy weight. Use
proper lifting techniques.
· Remove both battery cases as described in
Chapter 7.7.1.
· Pull the adjusting motor plug out of the
electronics module.
· The adjusting motor cable is secured inside
the frames with cable ties. Remove the cable
ties with the oblique pliers.
96
® ®
Invacare - Bora /Spectra
®
XTR Series