Table of Contents
Advertisement
JOG BOARD
r
1. ISA connector
This connector is used to connect the personal com-
puter.
2. Interrupt number (IRQ) setting jumper (P9)
Set the interrupt number (IRQ) where the jumper pin
is inserted.
3. I/O port setting jumper (P12)
Set the I/O address where the jumper pin is inserted.
4. RS422 control connector 1 (RS422-1)
This connector is used to connect a device that can
be controlled through a RS422 interface via the spe-
cial cable (accessory). This connection can be used
to control recording and playback on a VCR.
5. RS422 control connector 2 (RS422-2)
This connector is used to connect a device that can
be controlled through a RS422 interface via the spe-
cial cable (accessory). This connection can be used
to control recording and playback on a VCR.
6. JOGPAD connector (JOGPAD)
This connection is used to connect a JOGPAD via
the special cable (accessory).
7. Time code, reference input/output connector
(LTC/REF)
This connector is used to connect, via the special
time code and reference I/O cable (accessory), with
the time code input and output on a VCR, etc., and
with equipment that inputs an external signal for
synched composites (horizontal sync only).
4
w
q
t
y
u
e
i
•Time code input and output
This connector is used to connect with the time code
input and output on a VCR, etc. Make this connec-
tion only if the VCR has a time code signal (LTC) out-
put. The time code output is not a loop-through of
the signal that was input on the time code input.
Ver. 1.0 software does not support time code input
and output.
•Reference input and output
This connector is used to connect with equipment
that inputs an external sync signal. Be sure to input
the reference signal so as to maintain the frame pre-
cision. If a reference signal is not input, video audio,
and time code synchronization, and time code I/O
operation, cannot be guaranteed.
code output is a loop-through of the signal that was
input on the reference input.
8. Reference I/O 75-ohm terminator switch
Be sure to turn off the switch.
When terminating the reference (REF IN) in 75Ω ter-
mination, connect the termination (accessory) to the
REF OUT cable.
REF OUT cable
Coaxial relay plug
BCJ-J (accessory)
The reference
Termination
BCP-PT (accessory)
Advertisement
Table of Contents
