Table of Contents
Advertisement
2.) Board spacer (plastic type)
Main board
4. Plug the TARGA DV2000 board into the PCI slot that
is closest to the CPU (or the next closest slot, if the
board will not physically fit into the closest slot, it is
depends on the computer used). Here, firmly mount
the board spacer between the guide rails on the per-
sonal computer.
The assembly diagram shown
below is intended as an example. The actual con-
nection locations may differ depending on the model
of computer used.
Insert the video compression board with board spacer attached.
Illustration of the video compression board inserted into PC
11
Grooves in the rail guides
on the board spacer.
The rail guides
on the personal
computer
Connect the ground wire to the computer's chassis
(metal portion) only when the metal type of board spacer
is supplied.
Connect the ground wire of the video compression board (board
spacer) to the chassis (metal portion) of the system unit. (Unscrew
the screw and then use it to secure the wire in place.)
Then use the twist-tab wire to secure the board spacer to
the guide rails inside the computer.
The installation of the AY-PB500 board (TARGA DV2000
board) will differ depending on the computer used.
Refer to the appendix.
Chassis
(metal portion)
Ground wire
Guide rails
Twist-tab wire
Board spacer
Advertisement
Table of Contents
