Table of Contents
Advertisement
BIOS Setup
1. This procedure sets up the motherboard BIOS.
2. Open the BIOS setup screen. (The method of calling
up the BIOS setting screen varies depending on the
computer. Refer to the user's manual of the comput-
er.)
3. Set "Plug & Play OS" to "OFF". (The setting on your
computer system may be "Disable" or "No.")
4. Set Power Management to "OFF". (This may be
"Disable" or "NO".)
5. Save the settings, and quit the BIOS setup screen.
The computer starts up automatically.
6. Once the computer has started up, confirm that it is
operating normally; then quit Windows NT and turn
off the computer.
10
Installing the Video Compression
board (TARGA DV2000 board)
Note that due to structural differences, the installation
location may differ depending on the model of computer
used.
1. Remove the cover for the PCI slot (the white connec-
tor on the motherboard) that is closest to the CPU.
Note: The construction of some computers does not
physically allow the TARGA DV2000 board to be
plugged into the PCI slot that is closest to the
CPU. If this is the case with your computer,
remove the cover for the adjacent PCI slot.
2. Carefully remove the TARGA DV2000 board from its
anti-static protective pack. If you need to set the
board down, place it on top of this pack.
3. Attach the board spacer to the main board (the
longest board) among the TARGA DV2000 boards.
(Refer to the diagram below.)
The board spacer comes in two types (metal and
plastic) but only one type is enclosed with the unit.
1.) Board spacer (metal type)
Main board
Insert the main board
into the grooves in the
rail guides on the board
spacer.
Grooves in the rail guides
on the board spacer.
Advertisement
Table of Contents
