Table of Contents
Advertisement
Installing the AY-RP500 board
(JOG board)
1. Remove the cover from the ISA slot (the black con-
nector on the motherboard) that is the farthest away
from the CPU.
2. Carefully remove the AY-RP500 board (the JOG
board) from its anti-static protective pack.
need to set the board down, place it on top of this
pack.
3. Use the jumper pins to set the IRQ and the I/O port.
The permitted settings for the IRQ are 3, 4, 5, and 7;
the permitted settings for the I/O port are 230H,
240H, 330H, and 340H.
For IRQ, insert the jumper pin into jumper P9 and
set. (See item 2, page 4.)
•To set "3" as the IRQ:
Push in the jumper pin here.
p
IRQ3
8
8
IRQ4
8
8
IRQ5
8
8
IRQ7
8
8
•To set "4" as the IRQ:
IRQ3
8
8
Push in the jumper pin here.
IRQ4
8
8
p
IRQ5
8
8
8
8
IRQ7
•To set "5" as the IRQ:
IRQ3
8
8
8
8
IRQ4
Push in the jumper pin here.
IRQ5
8
8
p
IRQ7
8
8
•To set "7" as the IRQ (Factory setting) :
IRQ3
8
8
8
8
IRQ4
IRQ5
8
8
Push in the jumper pin here.
IRQ7
8
8
p
18
For the I/O port, insert the jumper pin into jumper
P12 and set. (See item 3, page 4.)
•To set "230H" as the I/O address
(Factory setting):
8
P 1
P 2
8
P 3
8
If you
•To set "240H" as the I/O address:
P 1
8
P 2
8
8
P 3
•To set "330H" as the I/O address:
P 1
8
P 2
8
P 3
8
•To set "340H" as the I/O address:
P 1
8
P 2
8
P 3
8
Since the JOG board uses IRQ and I/O port exclu-
sively, be certain to set a number that are not used
by any other device.
Confirm settings of other devices using the Windows
NT diagnostic program (page 19).
Note on IRQ Settings :
"5" and "7" are recommended.
If "5" and "7" are being used by another device,
set either "3" or "4". Because "3" and "4" are nor-
mally used for serial ports (COM1, COM2),
either "3" or "4" must be disabled in the BIOS
settings. (Set to "Disable" etc.)
only one serial port can be used.
For details on how to set the BIOS, refer to the
instruction manual that was provided with your
computer.
8
Do not push in jumper pins.
8
8
Push in the jumper pin here.
8
p
8
8
8
8
Push in the jumper pin here.
p
8
Push in the jumper pin here.
p
8
8
Push in the jumper pin here.
p
8
In this case,
Advertisement
Table of Contents
