Panasonic AY-RP500 Installation Manual page 31

23. The selected area
"Unformatted".
24. In "Partition" on the menu bar, click "Commit
Changes Now...".
25. At the message "Do you want to save changes?",
click .
Yes
26. The message "Disks were updated successfully".
Click .
OK
27. The message of the unformatted area of the disk
changes to "Unknown".
28. Click the "Unknown" area of the disk to select it.
29. In "Tools" on the menu bar, click "Format".
30. The format window opens. Click
and select "NTFS".
31. Do not set the format option. No guarantee is made
for the operation if "Quick format" is selected for for-
matting. The regular formatting facility must be
used.
32. Click Start . The warning display appears, but
click .
OK
33. When the message "Format complete" appears, click
. Then, click Close
OK
The format window will close.
34. On the menu bar (above the window) click "Delete"
in "Partition".
35. At the message "Confirm", select
36. The area will be indicated in crosshatch display.
37. Click the crosshatched area of the disk to select it.
38. On the menu bar (above the window) click "Create"
in "Partition".
29
will have the message
of "File system",
in the format window.
Yes .
39. The screen message will prompt you for the size of
the partition to be created. Do not modify anything,
but just click OK . When the confirmation mes-
sage is displayed, click
have the message "Unformatted".
40. In "Partition" on the menu bar, click "Commit
Changes Now...".
41. At the message "Do you want to save changes?",
click Yes .
42. The message "Disks were updated successfully".
Click .
OK
43. The message of the unformatted area of the disk
changes to "Unknown".
44. Click the "Unknown" area of the disk to select it.
45. In "Tools" on the menu bar, click "Assign Drive
Letter... "Select"Assign drive letter" (selection indicat-
ed by ). Click to bring up the list of characters
that can be assigned. Select "0".
After selecting the character, click
46. The message "Do you wish to continue?" appears.
Click Yes . The drive character will change.
47. Set up the other hard disk according to the same
procedure. However, assign "P" for the driver char-
acter.
48. When setup is finished, click "Exit" in "Partition" on
the menu bar.
Note: A hard disk for video use should be left in
"Unknown" status.
.The selected area will
Yes
OK
.