Table of Contents
Advertisement
( d ) Click
Change
in "Display Type".
( e ) Click
Have Disk
in "Display Modification".
( f ) The directory of the display driver is to be opened,
so enter
"C:¥TARGA2KDV¥WINNT¥Display" and click
( g ) Confirm that "Truevision DVR Display" is displayed
on the screen and click
( h ) The message "The drivers were successfully
installed" appears. Click
( i ) Click
Close
in "Display Types"
( j ) Click
Close
in "Screen Properties"
( k ) The message "You must restart your computer
appears. Click
Yes
.
( l ) Windows NT starts up. When the Control Panel
opens, close it.
When the message "A new graphics driver has been
installed" appears, click
(m) Click and drag the mark on the frame of the desktop
area in "Screen Properties" to adjust it for the
resolution of 1152 x 870 pixels. Here, confirm that
the font size is small and that the Refresh Frequency
is 75 Hz.
( n ) Click
, and click
Test
OK
test screen appears.
( o ) If the test screen is displayed correctly, click
( p ) Click
in "Display Properties" to close this
OK
screen. The resolution will change.
50
.
OK
.
OK
.
OK
"
8 8 8
.
OK
to enter test mode. The
.
Yes
6.
Installing new DVEdit
Insert a CD-ROM into the CD-ROM drive. (The case
where the CD-ROM drive is d:¥ is described below.)
Move the cursor to the Run command in the Start menu
and click the command. The Run window will be
displayed.
Type the command, "d:¥dvedit¥disk1¥setup.exe" in the
Open field of the Run window and click the
This starts the DVEdit installer, so start installing as
instructed on the panel. Start installing according to the
instructions on the panel shown.
After install is completed, the panel asks whether or not
to restart, so restart as shown on the panel. When the
icon DVEdit on the deskstop is double-clicked after
restart, the new version of DVEdit is ready for use.
OK
button.
Advertisement
Table of Contents
