Table of Contents
Advertisement
(d) If the following message appears during uninstall,
click
No to All
.
(e) Check disk scheduling
Enter "chkdsk /f c:" on the command prompt panel.
After that, You will be asked "Check disk
scheduling (Y/N)?"
So enter "y" on the command prompt panel.
This executes the check-disk in restarting.
( f ) Restart. (The check-disk automatically runs at
restart.)
Select "Shutdown" from "Start".
Add a check mark to "Restart Computer" and click
.
Yes
(g) Directory delete
If c:¥TARGA2KDV and subsequent directories remain
in Explorer after restart, delete all together with the
directories.
49
5.
Installing the New Targa Driver
(a) Installing the Targa driver
Insert a CD-ROM into the CD-ROM drive. (The case
where the CD-ROM drive is d:¥ is described below.)
Move the cursor to the Run command in the Start
menu and click the command. The Run window will
be displayed.
Type the command, "d:¥Targa¥disk1¥setup.exe" in
the Open field of the Run window and click the
button. This starts the Targa installer, so start
installing as instructed on the panel. The subsequent
operations are the same as installing a Targa driver
for the first time. Start installing according to the
instructions on the panel shown.
After install is completed, the panel asks whether or
not to restart, so restart as shown on the panel.
(b) After restart, double-click the icon "Display" on the
control panel.
(c) Select "Settings" from "Display Properties" and click
.
Display Type
OK
Advertisement
Table of Contents
