Setting Up The Snmp Network Service - Toshiba e-studio 3511 Network Administrator's Manual

Setting up the SNMP Network Service

In SNMP Network Service, you can enable or disable the SNMP to monitor the device status
using a network monitoring utility. If an administrator wants to monitor the device status with a
monitoring utility, programmed to fit the MIB, you must enable the SNMP and SNMP Traps.
1
2
3
4
5
6
7
8
•
NOTE:
•
NOTE:
Network Administrator's Guide — Setting up Network Settings
1) Enable SNMP
Select whether the SNMP monitoring with MIB is enabled or disabled. This must be
enabled to allow users to connect using TopAccessDocMon, TWAIN driver, File Down-
loader, and the Address Book Viewer.
2) Read Community
Enter the trap community name for the SNMP Traps.
If you specify a community name other than "public" for the Read Community, the
applications that use MIB (TopAccessDocMon, TWAIN driver, File Downloader, and
Address Book Viewer) will be unavailable. The SNMP communication of the printer
driver also will be unavailable, so that the obtaining the configurations, confirming
the department code, and obtaining the available boxes in e-Filing will be disabled.
3) Read Write Community
Enter the Read Write community name for the SNMP Traps.
If you specify a community name other than "private" for the Read Write Community,
the applications that use MIB (TopAccessDocMon, TWAIN driver, File Downloader,
and Address Book Viewer) will be unavailable. The SNMP communication of the
printer driver also will be unavailable, so that the obtaining the configurations, con-
firming the department code, and obtaining the available boxes in e-Filing will be
disabled.
63