Vision Fitness S7100 Suspension elliptical Service Manual page 64

cHapteR 8: SuSpenSion elliptical aSSeMbly GuiDe
8.3 aSSeMbly inStRuctionS - continueD
* remove the 4 console mounting screws
from the backside of the console. Connect the
heart rate wires coming from the mast to the
heart rate wires coming from the bottom of the
console. Plug the data cables into the board.
Pull any extra wire down into the console
mast. secure the console to the bracket
using the 4 console mounting screws removed
earlier. tighten with the screwdriver.
* Position the cover over the elevation bracket
and secure it with 2 silver bolts.
* Position the covers over the rear of the
incline frame and secure each cover in place
with 4 bolts each. tighten the bolts just until
the covers are snug.
* Plug the power cord into the power socket in
the front of the unit. Plug the other end of the
cord into the wall outlet. Make sure the power
switches at the bottom of the unit and on the
back of the console are in the on position.
60