Vision Fitness S7100 Suspension elliptical Service Manual page 62

cHapteR 8: SuSpenSion elliptical aSSeMbly GuiDe
8.3 aSSeMbly inStRuctionS - continueD
* take the left pedal assembly and lay it on the
ground in position on the left side of the machine and
insert the bearing end of the suspension arm into the
bracket of the incline arm. From the outside, insert a
hex head bolt with a flat washer through the bracket
and suspension arm. secure with a flat washer and
hex nut. Fully tighten, this joint must be vEry tight.
* repeat this step on the right side.
* take the front end of the left pedal arm and insert
it into the end of the crank arm. you will have to
slightly pry the pedal arm out in order to place it
into the bearing. rotate the crank arm / pedal arm
connection up to the 11 o'clock position (1 o'clock
right side) and insert the button head bolts with flat
washers and tighten.
* Press the inner crank arm bearing end cap in
place.
* repeat this step on the right side.
58