Vision Fitness S7100 Suspension elliptical Service Manual page 38

7.10 DRiVe belt ReplaceMent - continueD
5) once the ECB and drive axle assembly are loose, the drive belt can be removed from around the drive axle assembly allowing the ECB to
drop down outside of its bracket (Figures E & F).
fiGuRe e
6) once the ECB is dropped down outside of its bracket, the drive can be removed from around the ECB pulley (Figure G).
7) on the left side of the unit, move the mounting bearing from the drive axle assembly towards the middle of the frame. this will allow you to
move the belt around the drive axle assembly and off the unit (Figure h).
fiGuRe G
8) reverse steps 1-7 to install a new drive belt. NOTE: the s7100 has a 10 rib Gates Polyester drive belt. It should be tightened to a 188hz
(+/- 4hz) vibration frequency.
9) test the suspension elliptical for function as outlined in section 7.21.
34
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe f
fiGuRe H